BIG SHOTS Installation
Requirements:
Damp rag or cloth
1 pair of hands for small, 2 pairs of hands for large
Smooth, flat wall
Not following these directions will result in poor application and
poor adhesion to your wall. This will not constitute a refund or
reprint.
-
Keep box/roll for future storage
-
Unroll your BIG SHOTS and lay it flat on the floor. Allow 10 –
15 minutes to adjust to room temperature.
Find a good spot for your BIG SHOTS. Pick a smooth flat wall.
Clean the wall with a damp cloth and dry thoroughly. BIG SHOTS
will not stick to textured, dirty, stained or wet walls.
-
Do Not Use any soaps, household detergents, or other chemicals,
before installation. Just use a Damp Cloth or Rag. Otherwise you
may damage the adhesive.
-
Remove BIG SHOTS from its backing. Do not discard backing paper,
put it back into the tube or box. You’ll thank us later for this
tip.
-
Starting in the middle and working toward the edges, stick your
BIG SHOTS to the wall. Avoid touching the adhesive, your body
produced natural oils and can harm the adhesive. It’s ok if it
touches it self. Pull it apart slowly and continue.
-
You can now push out any bubbles working from the inside out. If
you have a huge bubble, pull up the closest edge, and lay it
back down. If your happy with its position, push firmly on it to
make sure it sticks. You can also use the squeegee, if one was
provided, to go over your BIG SHOTS a few times, the more the
better. Take great care on the edges pushing firmly. If one
curls up, push it back down.
-
If you do not like your BIG SHOTS new home, carefully pull it
back up and start over in a new spot.
If you are moving to a new home, or changing the BIG SHOTS to a
new location, put it on the backing paper it came with. If you
no longer have it, use wax paper on the back of it.
-
If treated properly, your BIG SHOTS will last many, many moons.
If you are having trouble, please email us at: iNFO
|
